Tuesday, May 30, 2017

Task list. This will be updated regularly.

Front Relay box

  • Will be mounted
  • Need to:


  • Create circuit diagram 
  • Create the BMS circuit connections diagram
  • Bus bars need to be reconfigured to fit. 

  • Plexiglas need to be cut to make box.

  • Rear Battery boxes

  • Will be mounted to the frame
  • Need to:


  • Create circuit diagram 
  • Create the BMS circuit connections diagram
  • Bus bars need to be reconfigured to fit. 

  • Lower battery frame needs to be cut to fit the box width.

  • Front Battery boxes

  • Will be mounted to the Z-bar
  • Need to:


  • Create circuit diagram 
  • Create the BMS circuit connections diagram
  • Bus bars have been reconfigured to fit. 

  • Top rails need to be cut and bolted down.

  • Water cooling pump


  • Will be mounted to the bottom of the I-beam
  • Need to:



  • Create circuit diagram 
  • Create hydraulic diagram
  • Create control program


  • Need to order:


  • Square U-bolts
  • Mounting plate 
  • Mounting bolts 
  • ø25mm id hose to/from pump 
  • Regulator switch 
  • Relay (check supply)
  • Reservoir tank (have) 

  • Vacuum Pump
  • Will be mounted to the front of the I-beam
  • Need to:


  • Create circuit diagram
  • Create Pneumatic diagram 
  • Create control program


  • Need to order:


  • Square U-bolts
  • Mounting plate 
  • Mounting bolts 
  • 3/8 hose from pump, what to booster check valve?
  • Regulator switch, Looking for MAP sensor with CAN output
  • Relay (check supply)
  • Reservoir tank (check supply) 
  • Check valve (check car)

  • Steering pump
  • Will be mounted at a much later date after the car is operational.
  • Will be mounted to the top of the I-beam on the passenger side between the windshield wiper fluid reservoir and the DMOC.
  • CAN codes have been found and are on a page specific to the pump.
  • Will require new hoses and fitting to be made.
  • Reservoir is built in and part of the return loop. 
  • Need to:


  • Create circuit diagram 
  • Create hydraulic diagram
  • Create control program

  • A/C compressor


  • Will be mounted at a much later date after the car is operational.
  • Will be mounted under the I-Beam on the drivers side.
  • Will require new hoses and fitting to be made.
  • Will require finding the CAN codes
  • Need to:


  • Create circuit diagram 
  • Create hydraulic diagram
  • Create control program
  • No comments:

    Post a Comment